Mixer Machine Spare Parts, Concrete Mixer Arm for Concrete and Asphalt Mixing Plant for Pavement Construction

Wear Parts for Concrete Mixers

Product Application

Suitable Brand: Twin Shaft Concrete Mixer

Suitable Mixer Type:
--DW 2.25/ --DW 2.5/ --DW 3.0/ --DW 3.5/ --DW 4.5/ --DW 6.0

Spare Parts We Can Supply:
--Right Lateral Arm / Left Lateral Arm / Central Arm
--Lateral Arm Counterparts / Central Arm Counterparts
--Left Arm Protection / Right Arm Protection
--Left Lateral Blade / Left Lateral Scraper / Right Lateral Blade / Right Lateral Scraper / Central Blade
--Discharge Door Cover
--Discharge Door Ledge
--End Liners
--Wall Liners

Material Analysis

Hardness: 52-62 HRC

Useful Life: Over 200,000 Cubic Meters of Concrete or 300,000 Tons of Asphalt

Material: High Chromium Cast Iron/Steel

Standard: CN: KM TB Cr 15-25-GTUS: ASTM A532 Class Two Type D
Strength of Extension: 380 N/mm²
Extension at Break: 1%
Shock Impact Resistance Value: >5 ak N.M/cm²
Flexural Strength: >600 ak N.M/cm²
Certification: ISO9001:2008
Metallographic Organization: M+M7C3+M23C6
Processing Type: Lost Foam Casting

Main Features

Our advanced production methods and equipment allow us to produce Ni-Hard and Hi-Chrome Iron castings with a Brinell hardness of over 650 for shovels and wear plates. Other parts such as mixing arms are made from alloy steel castings.

1. Making polyfoam gasification mold
2. Polyfoam gasification, combine the molds then dry
3. Spraying fireproof paint on the surface of polyfoam mold, then drying again.
4. Put the special sand box on the three-dimensional vibration compaction stage
5. Filled the sand box with dry sand, then strike-off
6. Putting the dry polyfoam mold on the sand, then fill different sand according to the technological requirements
7. Strike off the sand box after the process of vibration compaction
8. Covering the sand box with plastic sheet, put down the pouring cup, connect the negative-pressure system. Then pour steel liquid, the polyfoam disappears, and the steel liquid takes its place.
9. After casting condensation, release the vacuum, then take out the castings.