ZC-1210U-series pressure calibrator module use matters needing attention

ZC-1210U-series pressure calibrator module use precautions:
1. The ZC-1210U-series pressure calibrator module should be placed in a clean, non-corrosive environment. If there are special requirements, please indicate in the contract.
2. When the ZC-1210U-series pressure calibrator module is not in use, the power supply should be turned off. If it is not used for a long time, it should be charged once every three months.
3, ZC-1210U- Series pressure calibrator module overload enough, but never severe overload, will cause damage to the sensor, resulting in the instrument can not be used.
4, ZC-1210U-series pressure calibrator module sensor is a high-precision product, the surface of the silicon diaphragm should not collide with solids, otherwise it will damage the sensor.
5, there is no professional testing skills and special testing equipment, do not open the cover for maintenance, but also does not allow adjustment of internal devices, and the replacement of materials, or can not guarantee the reliability of the instrument.
6, do not let the electric iron and other heating elements close to the display in order to prevent burnt bad plastic material.
7, can not use gasoline, alcohol and other chemical solvents scrub panel.
8, ZC-1210U- series pressure calibrator module although seismic design, but should be handled with care much, especially at the site, to avoid Shuaidie, collision.
9. When using the internal DC 24V power supply of the ZC-1210U-series pressure calibrator module, do not short circuit, otherwise it may cause permanent damage to the instrument.

High Precision Cold Rolling Mill

High Precision Cold Rolling Mills focus on solution of thin gauge steel strip, special metal strip, metal foil rolling, requires high precision control and high speed running.

High precision rolling mill control is an automatic closed loop of control system: thickness gauge, PLC, hydraulic AGC, rolling drive and coiler drive, all these funtions are controlled by Siemens PLC in fast reaction and safety monitor.

Thin gauge steel strip means finished thickness below 0.08-0.3mm, foil 0.03mm, SS strip 0.1-0.3mm, Annealing furnaces are needed between rolling processes.

Type of Cold Rolling Mill are multiple rollers, 6high, 8high, 12high, 18high, 20high, which are chose as per input and output.

We anticipate your inquiry to go on further discussions.

20high Cold Rolling Mill


High Precision Cold Rolling Mill,6High Cold Rolling Mill,High Speed 6High Cold Rolling Mill,Precision Cold Rolling Mill

Wuxi Jinye Complete Set of Equipment Co.Ltd. , https://www.machinejinye.com